What should be ready before a dump truck arrives in Idaho Falls?

Mark the intended drop area before the truck reaches the property. Move cars, equipment and obstacles from the approach, and make sure the driver has room to enter, unload and leave. Confirm that the surface is firm enough for a loaded truck.

Should I use topsoil or fill dirt for a low spot in a Bonneville County yard?

Use Fill dirt when the job calls for building up grade or filling a depression before the finish layer goes down. Compact fill in lifts where the area will support traffic or a structure. Use Garden soil as the upper layer for planting areas, rather than as the main structural fill.

Is 3/4 Road Mix the right base for pavers or a shed pad?

3/4 Road Mix is the local name for a compactable crushed base, also called road mix or 3/4 minus. It works below pavers and shed pads when placed at the required depth and compacted in lifts. Remove soft material first and establish drainage away from the work area.

Which nearby town lies east of Idaho Falls?

Iona lies about 8 miles east of Idaho Falls in Bonneville County. Include the full property location and a clear delivery route when scheduling material for an address outside the city.

Idaho Falls, ID Gravel, Soil and Rock Delivery

Idaho Falls is a mid-size city in Bonneville County with four ZIP codes: 83401, 83402, 83404 and 83406. A gravel driveway needs a firm base, consistent grade and the right material for the surface. Idaho Rock Supply lists bulk aggregate, sand and soil for new drive construction, regrading and topping worn gravel.

Bulk materials for Idaho Falls driveways and yard work

For a compacted driveway base, use 3/4 Road Mix, also called 3/4 minus, road mix or crushed base. It follows the grading associated with ITD Section 703 3/4 inch aggregate base and includes fines that lock the material together under compaction. Pit Run, also called bank run or unprocessed gravel, fits building pads and fill areas where a less processed aggregate is wanted.

Snake River Rock is round rock used for decorative ground cover and visible areas around a property. Mason sand works for masonry work, bedding and leveling needs. Garden soil fits planting areas where finished soil is needed rather than structural fill.

Measure the length and width of each area, then multiply them for square footage. Multiply square footage by planned depth in feet for cubic feet, then divide by 27 for cubic yards. The calculator helps convert the project dimensions into an order quantity, while material weight and truck capacity determine the final delivery load.

Bonneville County ground, frost and drainage planning

Base depth depends on the intended load and the condition of the ground below it. A pedestrian paver area needs less compacted base than a vehicle driveway or shed pad. Place aggregate in manageable lifts and compact every lift before adding the next one.

Idaho uses a statewide frost-depth guide of 30 inches. Confirm frost and foundation requirements with the local building department before building a shed foundation, wall or other structure that requires a designed footing.

Drainage deserves attention before aggregate is placed. Ground behavior differs across Idaho: alluvial gravel in the Treasure Valley drains readily, while deep loess in the Palouse and clay in the Panhandle retain water. Check the existing soil, low areas and water flow at the job before choosing base thickness or adding Drain Rock for drainage zones.

Delivery planning for Idaho Falls and nearby towns

Delivery scheduling covers Bonneville County and surrounding communities based on access, load size and road conditions. Iona in Bonneville County lies about 8 miles east of Idaho Falls. Rigby in Jefferson County lies about 16 miles northeast, while Shelley in Bingham County lies about 19 miles south.

Rexburg in Madison County lies about 26 miles northeast, Blackfoot in Bingham County lies about 29 miles west and Sugar City in Madison County lies about 30 miles northeast. Orders for properties in 83401, 83402, 83404 or 83406 need a clear delivery location and a safe route from the street to the dump area.

Keep vehicles, trailers, tools and loose materials out of the unloading path. Mark the drop point, check overhead clearance and avoid soft ground where a loaded truck could sink or damage the surface. Book ahead when weather or road conditions affect access.

Plan the material quantity

Use the calculator to enter project length, width and depth before ordering. Select a delivery date online after confirming access, the drop location and the material needed for the job.

Idaho Falls, ID Rock, Gravel and Soil Delivery